Lenovo ThinkCentre A61 User Manual download pdf (Page 35)

Replacing a memory module

Attention

Do not open your computer or attempt any repair before reading the “Important safety

information” in the Safety and Warranty Guide that was included with your computer for

the computer. To obtain copies of the Safety and Warranty Guide, go to

http://www.lenovo.com/support.

This section provides instructions on how to replace a memory module.

Note: Your computer has support for two memory modules.

1. Remove the computer cover. See “Removing the cover” on page 9.

2. Remove the bezel and drive bay assembly. See “Accessing system board

components and drives” on page 10.

3. Remove any parts that might prevent access to the memory connectors.

4. Remove the memory module being replaced by opening the retaining clips as

shown.

5. Position the replacement memory module over the memory connector. Make

sure that the notch 1on the memory module aligns correctly with the

connector key2 on the system board. Push the memory module straight

down into the memory connector until the retaining clips close.

Figure 33. Removing the memory module

Figure 34. Installing the memory module

Chapter 3. Installing options and replacing hardware 27

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

No comments

Lenovo ThinkCentre A61 User Manual Page 35