Lenovo THINKCENTRE 8804 User Manual download pdf (Page 43)

2. Make sure that the cables are routed correctly before lowering the drive bay

assembly.

Important

Correctly route all power supply cables to avoid interference with the

drive bay assembly. Keep cables clear of the hinges and sides of the

computer chassis.

3. Lower the drive bay assembly and position the drive locks to the locked

position. Otherwise, you cannot close the computer cover.

4. Close the computer cover.

5. If a cover lock is installed, lock the cover.

6. Reconnect the external cables and power cords to the computer. See “Locating

connectors on the rear of your computer” on page 3.

7. If you are replacing the system board or microprocessor, you must update

(flash) the BIOS. See “Updating (flashing) BIOS from a diskette or CD-ROM.”

8. To update your configuration, see ″Using the Setup Utility program″ in the User

Guide.

Note:

In most areas of the world, Lenovo requires the return of the defective CRU.

Information about this will come with the CRU or will come a few days after the

CRU arrives.

Updating (flashing) BIOS from a diskette or CD-ROM

Important

Start the Setup Utility program to view your system information. See “Using

the Setup Utility program” in your User Guide or the Hardware Maintenance

Manual. If the serial number and the machine type/model listed on the Main

menu do not match what is printed on the label of your computer, you must

update (flash) the BIOS to change the serial number and the machine

type/model.

Chapter 2. Replacing hardware 35

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

No comments

Lenovo THINKCENTRE 8804 User Manual Page 43