Lenovo C52 User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
E-3
INSTALL THE
MONITOR
To connect the tilt/swivel base to the monitor, align
hooks with the sockets on bottom side of the
monitor, and gently push the base towards the front
of the monitor.
The 15-pin D-shell signal connector on the signal
cable will connect easily to the video adapter
output on your personal computer. Lock both
screws on the connector to ensure a firm
connection.
Turn the PC power switch ON. Then turn the
monitor power switch ON, by pressing the switch
inward. The green power indicator will light up.
Allow about 30 seconds for the CRT tube to warm
up. Data will be displayed on the screen.
If your display fails to function properly, please
first refer to the section "Troubleshooting" in this
manual.
POWER CORD
Check first to make sure that the power cord
you use is the correct type required for your
area.
This monitor has a universal power supply that
allows operation in either 100/120V AC or 220/
240V AC voltage area. No user-adjustment is
required.
First connect the power cord into your
monitor’s power input socket, and then plug
the other end into a 3-pin AC outlet. The power
cord may be connected to either a wall socket
or the power output socket on your PC, de-
pending on the type of power cord supplied
with your monitor.
For units to be used at 120V AC:
Use a UL Listed Cord Set consisting of a min.
No. 18 AWG, Type SVT or SJT three-con-
ductor a maximum of 15 ft. in length and a
parallel blade, grounding type attachment plug
rated 10A, 125V.
For units to be used at 240V AC (domestic
use):
Use a UL Listed Cord Set consisting of a min.
No. 18 AWG, Type SVT or SJT three-conduc-
tor cord a maximum of 15 ft. in length and a
tandem blade, grounding type attachment plug
rated 10A, 250V.
For units to be used at 220/240V AC (outside
of U.S.):
Use a Cord Set consisting of a min. No.18
AWG cord and grounding type attachment plug
rated 15A, 250V. The cord set should have
the appropriate safety approvals for the coun-
try in which the equipment will be installed and
marked HAR.
Page view 2
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments