Lenovo THINKCENTRE 8177 User Manual download pdf (Page 121)

3. Disconnect the signal cable and power supply cable from the drive being

replaced.

4. Remove any screws that secure the drive. Not all drives have screws.

5. Make sure the drive that you are installing is set correctly as either a master or

a slave device. Jumper the new drive the same as the drive being replaced.

Note: If you are installing a serial ATA drive, no master/slave jumpering is

necessary.

Refer to the documentation that comes with your drive for master/slave

jumper information.

6. Install the drive into the bay as shown.

Chapter 9. Replacing FRUs (Types 8149, 8177, and 8178) 115

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 227 228

No comments

Lenovo THINKCENTRE 8177 User Manual Page 121