Lenovo LXH-GJ17L3 User Manual

Contents CERTIFICATIONS -------------------------------------------------------------------- 2 NOTICE -----------------------------------------

HOW TO USE OSD The main menu will be displayed as follows (see figure 5). If OSD window is in Chinese when power on, press ▲ or ▼ to choose the next

3.1 FOCUS Adjust the picture Focus. 3.2 CLOCK Adjust the picture Clock. 4. LANGUAGE

Green monitor • The monitor has a power saving function that conforms to the VESA standard. When the computer input no signal, the monitor will ent

TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord

Screen image is not centered or sized properly. *Adjust pixel frequency (CLOCK) and FOCUS or press hot-key (AUTO). Picture has color defects *Adjust

ERROR MESSAGE & POSSIBLE SOLUTION NO SIGNAL INPUT 1. The computer is switched off. 2. The computer is dormancy. CABLE NOT CONNECTED : 1.

APPENDIX A SPECIFICATIONS Type TFT Color LCD Size 43.2cm(17") LCD Panel Pixel pitch 0.264mm( H ) x 0.264mm( V ) Video R,G,B Analog Interfa

APPENDIX B FACTORY PRESET TIMING TABLE STANDARD RESOLUTIONHORIZONTAL FREQUENCY VERTICAL FREQUENCY Dos-modo 720 × 400 31.47kHz 70Hz 640 × 480 31

APPENDIX C CONNECTOR PIN ASSIGNMENT 1561011 15 Figure 6 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red

CE certificate This shipped version of this device complies with the requirements of the EEC directive 89/336/EEC “Electromagnetic comp

PRECAUTIONS z Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. z D

SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • You may find slightly unev

INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel Base 1. During installation, pl

CONTROLS AND CONNECTORS Adapter Connecting the adapter: Connect one end of the adapter to back of the monitor and connect the other end to the powe

ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your

OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power switch to turn the monitor on or off. The other control knobs are located at front panel

FRONT PANEL CONTROL • Power / Power indicator : Press this knob to switch ON/OFF of monitor’s power. and display the monitor’s state. Blue —