Lenovo Storage Array 8332 User Manual download pdf (Page 24)

CAUTION:

Operation of the enclosure system with any modules missing will disrupt the

airflow and the drives will not receive sufficient cooling. It is essential that all

openings are filled before operating the unit.

Installing the enclosure in a rack

A set of rack-mounting rails is provided with the system for installing the SMC -

Storage Array in a 48.26-cm (19-inch) rack cabinet. These rails have been designed

and tested to handle the maximum weight of the enclosure and to ensure that

multiple enclosures may be installed without loss of space within the rack. Use of

other mounting hardware may cause some loss of rack space.

Contact your supplier to ensure suitable mount rails are available for the rack you

are using.

Rail kit assembly

Refer to the Rail Kit Installation Guide for instructions on assembling the rail kit.

1Rear rack post

2Clamping screws

3Rack bracket ASM

4Front rack post

5Slide screw (4)

6Slide washer (4)

Enclosure installation

To install the enclosure, do the following:

1. Check for damage.

2. Lift enclosure and align with front rails.

3. Carefully insert enclosure slides into rack rails and push fully home.

4. Tighten rear screws.

5. Withdraw enclosure until it reaches hard stops (approximately 400 mm).

6. Tighten front screws.

Figure 15. Rack mount rail kit

16 User Guide

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

No comments

Lenovo Storage Array 8332 User Manual Page 24