Lenovo ThinkServer RD540 User Manual download pdf (Page 24)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 6

QLflash Options

QLflash.exe <1...N | ALL> [options]

/SLT

SLT: Sets the application to silent mode

Use application return code for success or failure

/SIL=filename.ext

SIL: Load multiflash image from file

/PRV | /VPP | /PRN

PRV: Print firmware versions

VPP: Print VPD contents

PRN: Print MAC addresses and worldwide port name (WWPN)

/CFU=filename.ext | /CFS=filename.ext | /CFC=filename.ext

CFU: Flash board configuration from file

CFS: Save board configuration file (need template file BRDCFG.DAT)

CFC: Compare board configuration to a binary file

/NVU=filename.ext | /NVS=filename.ext | /NVC=filename.ext

NVU: Flash NVRAM from file

NVS: Save NVRAM to file (need template file NVRAM.DAT)

NVC: Compare Flash to NVRAM file

/UIL=filename.ext | /UIS=filename.ext | /UIC=filename.ext

UIL: Flash user information data from file

UIS: Save user information data to file

UIC: Compare user information data to a binary file

Adapter Configuration Utility

This section provides detailed configuration information for advanced users who want to customize the

configuration of the 8200 and 3200 Series Adapters and the connected devices. You can configure the

adapters using the CNA Function Configuration utility.

Note: • If you used an FC RAID target in a cluster environment, you should enable the

Enable Target Reset = Enabled (Advanced Adapter Settings).

• Use the /I option if the update utility, QLflash, does not detect your adapter.

• QLogic recommends disabling the internal disk before installing the OS or

booting to the FCoE disk.

Note: The CNA Function Configuration utility does not run on SUN™ SPARC

systems.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 131 132

No comments

Lenovo ThinkServer RD540 User Manual Page 24