Lenovo RD210 User Manual download pdf (Page 102)

Removing the PCI riser-card assembly

To remove a PCI riser-card assembly, complete the following steps:

1. Read the safety information in “Safety” on page vii and “Installation guidelines”

on page 39.

2. Turn off the server and peripheral devices and disconnect the power cords and

all external cables.

Note:

When you disconnect the power source from the server, you will lose the

ability to view the LEDs because the LEDs will not be lit with the power source

removed. Before disconnecting the power source, make a note of which LEDs

are lit, including the LEDs that are lit on the operation information panel, the

EasyLED panel, and LEDs that are lit inside the server on the system board;

then, see “EasyLED” on page 157 for information on how to solve the problem.

3. Remove the cover (see “Removing and replacing the cover” on page 43).

4. If an adapter is installed in the riser-card assembly, disconnect any cables that

are connected to the adapter.

5. Grasp the rear of the riser-card assembly from the rear and lift it out of the PCI

riser-card slot on the system board.

1 PCI riser-card assembly (full-height, full-length adapters)

2 PCI riser-card assembly (low-profile adapters)

3 PCI riser connector 1

4 PCI riser connector 2

6. Remove the adapter, if one is present, from the riser-card assembly.

7. Set the adapter and riser-card assembly aside.

Installing the PCI riser-card assembly

To replace a PCI riser-card assembly, complete the following steps:

1. Read the safety information in “Safety” on page vii and “Installation guidelines”

on page 39.

86 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide

1 ... 101 102 103 ... 204

No comments

Lenovo RD210 User Manual Page 102