Lenovo RD120 User Manual download pdf (Page 67)

Installing a SATA tape drive in a 2.5-inch model server

To install a tape drive in a 2.5-inch model server, complete the following steps:

1. Read the safety information that begins on page v and “Installation guidelines”

on page 29.

2. Turn off the server and peripheral devices, and disconnect the power cords

and all external cables.

Attention: In a dc power environment, only trained service personnel other

than Lenovo service technicians are authorized to connect or disconnect power

to the dc power supply. See the documentation that comes with each dc power

supply.

3. If you installed the space filler from the tape enablement kit onto the tape-drive

assembly, remove it now.

4. Remove the server cover (see “Removing the cover” on page 31).

5. Remove the fan-bracket assembly (see “Removing the fan-bracket assembly”

on page 70).

6. Remove the filler panel from the tape-drive bay.

7. From the inside of the server, thread the tape-drive end of the cables for your

tape drive through the rear of the tape-drive bay and out the front of the

server.

8. Connect the cable or cables to the back of the tape drive.

9. Push the tape-drive assembly into the tape-drive bay, gently pulling the cables

farther into the server as you do so, until the tape-drive assembly stops.

10. Push the tray handle to the closed (locked) position.

11. Connect the cable connectors to the following system-board connectors (see

“System-board internal cable connectors” on page 20 for the location of the

connectors):

v Signal connector: SATA tape drive signal connector, J102

v Power connector: tape-drive power connector, J100

The

following illustration shows the routing of the SATA tape drive signal cable.

Important: Make sure that the cables avoid any fan connectors.

Chapter 2. Installing optional devices 53

1 ... 66 67 68 ... 118

No comments

Lenovo RD120 User Manual Page 67