Lenovo ThinkServer RD120 User Manual download pdf (Page 31)

2.5-inch drives

To install a drive in a hot-swap bay, complete the following steps:

Attention: To maintain proper system cooling, do not operate the server for more

than 10 minutes without either a drive or a filler panel installed in each bay.

1. Read the safety information that begins on page v, and “Installation guidelines”

on page 7.

2. Remove the filler panel from one of the empty hot-swap bays.

3. Install the hard disk drive in the hot-swap bay:

a. Make sure that the tray handle is open (that is, perpendicular to the drive).

b. Align the drive assembly with the guide rails in the bay.

c. Gently push the drive assembly into the bay until the drive stops.

d. Push the tray handle to the closed (locked) position.

e. Check the hard disk drive status LED to verify that the hard disk drive is

operating correctly.

If the amber hard disk drive status LED for a drive is lit continuously, that

drive is faulty and must be replaced. If the green hard disk drive activity LED

is flashing, the drive is being accessed.

Note:

You might have to reconfigure the disk arrays after you install hard disk

drives. See the RAID documentation on the ThinkServer Documentation DVD

for information about RAID controllers.

you have other optional devices to install or remove, do so now. Otherwise, go to

“Completing the installation” on page 29.

Installing a tape drive

For information about installing an optional tape drive, see the User Guide on the

ThinkServer Documentation DVD, which comes with the server.

Chapter 2. Installing optional devices 17

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

No comments

Lenovo ThinkServer RD120 User Manual Page 31