Lenovo THINKSERVER TS100 6434 User Manual download pdf (Page 29)

The following illustration shows the dual inline memory module (DIMM)

2connectors and corresponding LEDs 1 on the system board.

Attention: Static electricity that is released to internal server components when

the server is powered-on might cause the server to stop, which might result in the

loss of data. To avoid this potential problem, always use an electrostatic-discharge

wrist strap or other grounding system when working inside the server with the

power on.

To install a DIMM, complete the following steps:

1. Read the safety information that begins on page v and “Installation guidelines”

on page 7.

2. Turn off the server and peripheral devices, and disconnect the power cords and

all external cables.

3. Remove the side cover (see “Removing the side cover” on page 10).

4. Locate the DIMM connectors on the system board. Determine the connectors

into which you will install the DIMMs. Install the DIMMs in the sequence

shown in the following table.

Table 4. DIMM installation sequence

Number of DIMMs Installation sequence (connectors)

1 1

2 (interleaved configuration) 1, 3

3 The use of three DIMMs is not supported

4 (interleaved configuration) 1, 3, 2, 4

Chapter 2. Installing optional devices 15

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 109 110

No comments

Lenovo THINKSERVER TS100 6434 User Manual Page 29