Lenovo 6523 User Manual download pdf (Page 117)

Installing a microprocessor and fan sink

To install the microprocessor, complete the following steps:

1. Touch the static-protective package that contains the microprocessor to any

unpainted metal surface on the server. Then, remove the microprocessor from

the package.

2. Remove the protective cover, tape, or label from the surface of the

microprocessor socket, if any is present.

3. Rotate the release lever on the microprocessor socket to the fully open

position.

Attention: Make sure that the release lever on the microprocessor socket is

in the fully open position before you insert the microprocessor in the socket.

Failure to do so might result in permanent damage to the microprocessor,

microprocessor socket, and system board.

4. Carefully grasp the microprocessor and place the microprocessor into the

microprocessor socket.

Note: To maintain correct orientation between the microprocessor and the

microprocessor socket during installation, observe the following information:

v The microprocessor has two notches that are keyed to two tabs on the

sides of the socket.

v A triangle-shaped indicator on one corner of the microprocessor points to a

45-degree angle on one corner of the socket.

v Do not use excessive force when you press the microprocessor into the

socket.

5. Close the microprocessor bracket frame; then, close the microprocessor

retention latch and lock it securely in place.

6. Install the fan sink:

Chapter 6. Installing and replacing customer replaceable units 101

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 215 216

No comments

Lenovo 6523 User Manual Page 117