Lenovo 6523 User Manual download pdf (Page 70)

Installing a simple-swap hard disk drive

This procedure applies only to server models that have simple-swap SATA hard disk

drives.

Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all

power from the server you remove or install a simple-swap hard disk drive.

To install a simple-swap hard disk drive, complete the following steps:

1. Touch the static-protective package that contains the drive to any unpainted

metal surface on the server; then, remove the drive from the package and place

it on a static-protective surface.

2. Align the drive assembly with the guide rails in the bay.

3. Pull the loops of the drive assembly toward each other; then, carefully slide the

drive assembly into the drive bay until it clicks into place, and release the loops.

Note: Do not release the loops on the drive assembly until it is completely

seated.

4. Install the lower bezel (see “Installing the lower bezel” on page 36).

5. Lock the side cover.

6. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

Power and signal cables for internal drives

The server uses cables to connect SATA attached, simple-swap SATA, hot-swap

SATA and hot-swap SAS devices to the power supply and to the system board.

(See “System-board internal connectors” on page 19 for the location of

system-board connectors.) Review the following information before connecting

power and signal cables to internal drives:

54 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 215 216

No comments

Lenovo 6523 User Manual Page 70