Lenovo TS200V User Manual download pdf (Page 43)

6. Slide the new optical drive into the optical drive bay from the front of the

server until the optical drive snaps into position.

7. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on

page 19.

8. Continue at “Connecting a SATA drive.”

What to do next:

v To work with another piece of hardware, go to the appropriate section.

v To complete the installation or replacement, go to “Completing the parts

replacement” on page 44.

Connecting a SATA drive

You can connect a SATA optical drive or a SATA hard disk drive to an available

SATA connector on the system board.

To connect a SATA drive, do the following:

1. Connect one end of the signal cable to the SATA drive and the other end to an

available SATA connector on the system board. See “System-board internal

connectors” on page 14.

Figure 16. Installing the optical drive

Chapter 5. Installing or replacing customer replaceable units 27

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

No comments

Lenovo TS200V User Manual Page 43