Lenovo TS200V User Manual download pdf (Page 44)

2. Locate an available five-wire power connector and connect it to the SATA drive.

Installing or replacing the secondary hard disk drive

Attention

Do not open your server or attempt any repair before reading and

understanding the “Safety” on page v and the Safety Information book. To

obtain a copy of the Safety Information book, go to:

http://www.lenovo.com/support

This section provides instructions on how to install or replace the secondary hard

disk drive.

Installing a secondary hard disk drive

To install a secondary hard disk drive, do the following:

1. Remove all media from the drives and turn off all attached devices and the

server. Then, disconnect all power cords from electrical outlets and disconnect

all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 18.

3. Locate the secondary hard disk drive bay. See “Internal drives” on page 16.

Figure 17. Connecting a SATA optical drive

Figure 18. Connecting a SATA hard disk drive

28 Installation and User Guide

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 95 96

No comments

Lenovo TS200V User Manual Page 44