Lenovo TS200V User Manual download pdf (Page 61)

interference with reinstalling the server cover.

4. Position the server cover on the chassis so that the rail guides on the bottom of

the server cover engage the rails on the chassis. Then, slide the cover to the

front of the server until it snaps into position.

5. Install the screws to secure the server cover.

6. Lock the server cover if you have a server cover lock. See “Integrated cable

lock” on page 46 or “Padlock” on page 47.

7. Reconnect the external cables and power cords to the server. See “Front view”

on page 11 and “Rear view” on page 12.

8. Depending on the parts you installed or replaced, you might need to confirm

the updated information in the Setup Utility program. Refer to Chapter 6,

“Configuring the server,” on page 49.

Note: In most areas of the world, Lenovo requires the return of the defective

Customer Replaceable Unit (CRU). Information about this will come with the CRU

or will come a few days after the CRU arrives.

Updating the server configuration

When you start the server for the first time after you install or remove an internal

option or external device, you might receive a message that the configuration has

changed. The Setup Utility program starts automatically so that you can save the

new configuration settings.

Some options have device drivers that you must install. For information about

installing device drivers, see the documentation that comes with each option.

Figure 33. Reinstalling the server cover

Chapter 5. Installing or replacing customer replaceable units 45

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 95 96

No comments

Lenovo TS200V User Manual Page 61