Lenovo TS200V User Manual download pdf (Page 70)

10. Press Y when prompted to confirm the exit.

Deleting RAID volumes

This section describes how to use the Intel Matrix Storage Manager option ROM

configuration utility to delete RAID volumes.

To delete RAID volumes, do the following:

1. Press Ctrl+I when prompted to enter the Intel Matrix Storage Manager option

ROM configuration utility during the server startup.

2. Use the up and down arrow keys to select Delete RAID Volume and press

Enter.

3. Use the arrow keys to select the RAID volume to be deleted and press Delete.

4. When prompted, press Y to confirm the deletion of the selected RAID volume.

Deleting a RAID volume will reset the hard disk drives to non-RAID.

5. After deleting a RAID volume, you can:

v Return to step 2 to delete additional RAID volumes.

v See “Creating RAID volumes” on page 53 for RAID volume creation.

v Use the up and down arrow keys to select Exit and press Enter.

v Use the up and down arrow keys to select Reset Disks to Non-RAID and

press Enter.

a. Use the arrow keys and the space key to mark the hard disk drives to be

reset, and then press Enter to complete the selection.

b. When prompted, press Y to confirm the reset action.

c. After completing the Reset Disks to Non-RAID function, you can:

– Return to step 2 to delete additional RAID volumes.

– See “Creating RAID volumes” on page 53 for RAID volume creation.

– Use the up and down arrow keys to select Exit and press Enter.

Updating system programs

This section contains information about updating the POST/UEFI and recovering

from a POST/UEFI update failure.

This section provides information about the following topics:

v “Using system programs”

v “Updating (flashing) the UEFI from a disc” on page 55

v “Updating (flashing) the UEFI from your operating system” on page 55

v “Recovering from a POST/UEFI update failure” on page 56

Using system programs

System programs are the basic layer of software built into your server. System

programs include the POST, the UEFI code, and the Setup Utility program. The

POST is a set of tests and procedures that are performed each time you turn on

your server. The UEFI is a layer of software that translates instructions from other

layers of software into electrical signals that the server hardware can execute. You

can use the Setup Utility program to view and change the configuration and setup

of your server.

Your server system board has a module called electrically erasable programmable

read-only memory (EEPROM, also referred to as flash memory). You can easily

54 Installation and User Guide

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 95 96

Comments to this Manuals

No comments

Lenovo TS200V User Manual Page 70

Comments to this Manuals

Related products and manuals for Servers Lenovo TS200V