Lenovo TS200V User Manual download pdf (Page 41)

7. Position the new memory module over the memory slot. Make sure that the

notch 1 on the memory module aligns correctly with the key 2 in the

memory slot. Press the memory module straight down into the memory slot

until the retaining clips close.

8. Reinstall all parts that have been removed.

What to do next:

v To work with another piece of hardware, go to the appropriate section.

v To complete the installation or replacement, go to “Completing the parts

replacement” on page 44.

Installing or replacing the optical drive

Attention

Do not open your server or attempt any repair before reading and

understanding the “Safety” on page v and the Safety Information book. To

obtain a copy of the Safety Information book, go to:

http://www.lenovo.com/support

This section provides instructions on how to install or replace the optical drive.

To install or replace an optical drive, do the following:

1. Remove all media from the drives and turn off all attached devices and the

server. Then, disconnect all power cords from electrical outlets and disconnect

all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 18.

3. Remove the front bezel. See “Removing and reinstalling the front bezel” on

page 19.

4. Depending on whether you are installing or replacing an optical drive, do one

of the following:

v If you are installing a secondary optical drive, remove the plastic panel in the

front bezel for the drive bay you want to use. If there is a metal static shield

installed in the drive bay, remove the metal static shield.

Figure 13. Installing a memory module

Chapter 5. Installing or replacing customer replaceable units 25

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 95 96

No comments

Lenovo TS200V User Manual Page 41