Lenovo RS210 User Manual download pdf (Page 136)

6. Release the loops of the drive tray.

7. Insert the filler panel into the bay to cover the drive.

Note: If the server is configured for RAID operation using a RAID controller, you might have to

reconfigure your disk arrays after you install hard disk drives. See the RAID controller documentation

for additional information about RAID operation and complete instructions for using the RAID

controller.

8. Go to “Completing the FRU replacement” on page 173.

Removing a hot-swap hard disk drive

The 3.5-inch drive hot-swap server models support either two SAS 3.5-inch hard disk drives or two SATA

3.5-inch hard disk drives. The 2.5-inch drive hot-swap server models support four 2.5-inch SAS hard disk

drives.

The removal and installation procedures are the same for any of these drives. The illustrations in this

procedure show 3.5-inch SAS drives.

To remove a hot-swap hard disk drive, complete the following steps.

Attention: To avoid damage to the hard disk drive connectors, make sure that the server cover is in

place and fully closed whenever you install or remove a hard disk drive.

1. Move the handle 1 on the drive to the open position (perpendicular to the drive).

2. Slide the release latch (gray on 3.5-inch hard drives and orange on 2.5-inch hard drives) gently to the

left to unlock the drive handle.

128 ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual

1 ... 135 136 137 ... 244

No comments

Lenovo RS210 User Manual Page 136