Lenovo RS210 User Manual download pdf (Page 172)

Note: Route the DVD drive cable 2 through the fan cage hole on the left of fan 1.

5. Connect the DVD drive cable to the system board connector 1.

6. Reconnect the DVD drive power cable to the power supply cable.

7. Reinstall the DVD drive (see “Replacing a DVD drive”).

8. Reinstall the riser-card assembly (see “Installing the riser-card assembly” on page 158).

9. Go to “Completing the FRU replacement” on page 173.

Replacing a DVD drive

To replace a DVD drive, complete the following procedures:

Removing a DVD drive

To remove a DVD drive, complete the following steps:

1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained

service technicians” on page 115.

2. Turn off the server and peripheral devices and disconnect all power cords.

3. Remove the cover (see “Removing and installing the cover” on page 119).

4. Pull the release tab 1 (the rear of the drive-retention clip) toward the right side of the server to

release the clip; then, while you pull the tab, push the drive out of the bay.

Note: You might have to push the right-rear corner of the drive toward the front of the server to

move the drive initially.

164 ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual

1 ... 171 172 173 ... 244

No comments

Lenovo RS210 User Manual Page 172