Lenovo RS210 User Manual download pdf (Page 227)

2. When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed on the screen for only

a few seconds. You must press F1 quickly.) If you have set both a power-on password and an

administrator password, you must type the administrator password to access the full Setup utility

menu.

3. From the Setup utility main menu, select System Settings.

4. On the next screen, select Integrated Management Module.

5. On the next screen, select Network Configuration.

6. Find the IP address and write it down.

7. Exit from the Setup utility.

Logging on to the Web interface

To log on to the Web interface to use the remote presence functions, complete the following steps:

1. Open a Web browser and in the address or URL field, type the IP address or host name of the IMM

to which you want to connect.

Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMM assigns a static IP

address of 192.168.70.125.

2. On the Login page, type the user name and password. If you are using the IMM for the first time,

you can obtain the user name and password from your system administrator. All login attempts are

documented in the event log.

Note: The IMM is set initially with a user name of USERID and password of PASSW0RD (passw0rd

with a zero, not a the letter O). You have read/write access. You must change the default password

the first time you log on.

3. On the Welcome page, type a timeout value (in minutes) in the field that is provided. The IMM will

log you off of the Web interface if your browser is inactive for the number of minutes that you

entered for the timeout value.

4. Click Continue to start the session. The System Health page provides a quick view of the system

status.

Enabling the Intel Gigabit Ethernet Utility program

The Intel Gigabit Ethernet Utility program is part of the server firmware. You can use it to configure the

network as a startable device, and you can customize where the network startup option appears in the

startup sequence. Enable and disable the Intel Gigabit Ethernet Utility program from the Setup utility.

Configuring the Gigabit Ethernet controllers

The Ethernet controllers are integrated on the system board. They provide an interface for connecting to a

10 Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables

simultaneous transmission and reception of data on the network. If the Ethernet ports in the server

support auto-negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or

1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and automatically operate at

that rate and mode.

You do not have to set any jumpers or configure the controllers. However, you must install a device

driver to enable the operating system to address the controllers. For device drivers and information about

configuring the Ethernet controllers, see the Intel Hartwell 82574L Gigabit Ethernet Software CD that comes

with the server. To find updated information about configuring the controllers, complete the following

steps.

Note: Changes are made periodically to the Lenovo Web site. The actual procedure might vary slightly

from what is described in this document.

Chapter 8. Configuring the server 219

1 ... 226 227 228 ... 244

Comments to this Manuals

No comments

Lenovo RS210 User Manual Page 227

Comments to this Manuals

Related products and manuals for Servers Lenovo RS210