Lenovo RS210 User Manual download pdf (Page 99)

Table 5. DSA Preboot messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

v See Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are

customer replaceable units (CRU) and which components are field replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service

technician.

v Go to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints, tips, and new

device drivers or to submit a request for information.

Message

number Component Test State Description Action

201-810-xxx Memory Memory Test Aborted Test stopped:

unknown error

code xxx

received in

COMMONEXIT

procedure.

1. Turn off and restart the system.

2. Run the test again.

3. Make sure that the DSA code is at the latest level.

For the latest level of DSA code, go to

http://www.lenovo.com/support.

4. Make sure that the server firmware is at the latest

level. The installed firmware level is shown in the

DSA event log in the Firmware/VPD section for

this component. For more information, see

“Updating the firmware” on page 212.

5. Run the test again.

6. If the failure remains, go to the Lenovo Web site

for more troubleshooting information at

http://www.lenovo.com/support..

201-901-xxx Memory Memory Test Failed Test failure:

single-bit error,

failing DIMM

1. Turn off the system and disconnect it from the

power source.

2. Reseat DIMM z.

3. Reconnect the system to power and turn on the

system.

4. Make sure that the DSA code is at the latest

level. For the latest level of DSA code, go to

http://www.lenovo.com/support.

5. Make sure that the server firmware is at the

latest level. The installed firmware level is

shown in the DSA event log in the

Firmware/VPD section for this component. For

more information, see “Updating the firmware”

on page 212.

6. Run the test again.

7. Replace the failing DIMMs.

8. Re-enable all memory in the Setup utility (see

“Using the Setup Utility” on page 200).

9. Run the test again.

10. Replace the failing DIMM.

11. If the failure remains, go to the Lenovo Web site

for more troubleshooting information at

http://www.lenovo.com/support..

Chapter 4. Diagnostics

1 ... 98 99 100 ... 244

Comments to this Manuals

No comments

Lenovo RS210 User Manual Page 99

Comments to this Manuals

Related products and manuals for Servers Lenovo RS210